User`s manual

BIOS
Page 4-17
MODEM Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your
system. Activity of the selected IRQ always awakens the system. Default is IRQ 3.
Options: N/A, 3, 4, 5, 7, 9, 10, 11
Suspend Mode
enabled and after the set time of system inactivity, all devices except the CPU will
be shut off.
Options: Enabled, Disabled.
HDD Power Down
When enabled and after the set time of system inactivity, the hard disk drive will be
powered down while all other devices remain active.
Options: Enabled, Disabled.
Soft-Off by PWRBTN
Use this to select your soft-off function. The default is Instant Off.
Instant Off: Turns off the system instantly.
Delay 4 Second : Turns off the system after a 4 second delay. If momentary
press of button, the system will go into Suspend Mode. Press
the power button again to make system back to work.
CPU THRM-Throttling
This item sets the percentage of time that the CPU is idled if CPU throttling is
initiated by excess heat. The default setting is 50%.
Options: 12.5%, 25.0%, 37.5%, 50.0%, 62.5%, 75.0%, 87.5%.
PowerOn by PCI Card
An input signal form PME on the PCI card awakens the system from a soft off state.
Options: Enabled, Disabled.
Power On by Ring/LAN
When enabled, any modem or LAN activity awakens the system from power
savings mode.
Options: Enabled, Disabled.
USB Wake-Up From S3
When enabled, any USB activity awakens the system from power savings mode.
Options: Enabled, Disabled.