Manual

4 Installation

4.2 Printer

Printer DPU 414

The Eppendorf Thermal Printer DPU 414 can be connected to the serial interface

RS-232 C of the BioPhotometer (see Section 11, "Ordering information").

– Insert the printer cable into the printer connection socket of the BioPhotometer (see

photo) and tighten the safety screws on the plug to secure.

– Connect the printer cable to the printer and tighten the safety screws on the plug to

secure.

– Connect up to the power supply using a 115 V or 230 V mains cable.

Setting the BioPhotometer

printer function

– Select the function "Printer DPU 414" in the function list, and conﬁrm.

Printer DPU 414

– Check the printer settings. If necessary, set the printer for use with the

BioPhotometer, as described in the printer supplement.

Printer settings for working with the BioPhotometer:

Dip SW-2

Settings made by the user are not relevant for the group "Dip SW-2" because the

BioPhotometer assumes these settings automatically in accordance with the

language version selected.

Dip SW-1

1 (OFF) : Input = Serial

2 (ON) : Printing Speed = High

3 (ON) : Auto Loading = ON

4 (OFF) : Auto LF = OFF

5 (ON) : Setting Command = Enable

6 (OFF) : Printing

7 (ON) : Density

8 (ON) : = 100 %

Dip SW-3

1 (ON) : Data Length = 8 bits

2 (ON) : Parity Settings = No

3 (ON) : Parity Conditions = Odd

4 (OFF) : Busy Control = XON/XOFF

5 (OFF) : Baud

6 (ON) : Rate

7 (ON) : Select

8 (ON) : =9600 bps

04_Installation_e.fm Seite 55 Montag, 20. Februar 2006 10:50 Uhr