Service manual

LX-300+/1170 Revision C
Appendix EEPROM Address Map
1
09
45H
Software
0slash
Buzzer
----
Auto CR
----
----
----
b0: Software
(0:ESC/P 1:IBM 2381 Plus)
b1: 0 slash (0: off 1: on)
b2: Buzzer (0: on 1:off)
b3: Reserved
b4: Auto CR(IBM) (0: off 1:
on)
b5: Reserved
b6: Reserved
b7: Reserved
00H 00H
46H-
49H
Reserved 00H 00H
4AH
Panel mask pattern
1
b0: LOAD/EJECT function is
masked.
b1: LF/FF function is masked.
b2: TEAR OFF function is
masked.
b3: Micro Adjust function is
masked.
b4: Reserved
b5: Reserved
b6: Reserved
b7: Reserved
00H 00H
4BH
Panel mask pattern
2
b0: Font function is masked.
b1: Reserved
b2: Pause function is masked.
b3: Reserved
b4: Reserved
b5: Reserved
b6: Reserved
b7: Reserved
00H 00H
4CH
Manual feed wait
time
3to30(by0.1sec.),00H:1.5sec.
(same as default)
00H
(1.5 sec.)
00H
(1.5 sec.)
Table 7-13. EEPROM Address Map (continued)
Address Explanation Setting
QPIT
Settings
Factory
Settings
4DH Tear-off wait time
3to30(by0.1sec.),00H:3sec.
(same as default)
00H
(3 sec.)
00H
(3 sec.)
4EH,
4FH
Tear-off adjustment
value
-432 to +432 (-25.4mm(-1inch) to
0mm +25.4mm (inch), by
0.0588mm (1/432 inch))
0000H 0000H
50H Serial baud rate
0: 19200 bps
1: 9600 bps
2: 4800 bps
3: 2400 bps
4: 1200 bps
5: 600 bps
6: 300 bps
00H
(19200)
00H
(19200)
51H Serial parity
0: None
1: Even
2: Odd
3: Ignore
00H
(None)
00H
(None)
52H Input Buffer
0: On (8kbyte)
1: Off (1byte)
00H 00H
53H Packet mode
0: Auto
1: On
2: Off
00H 00H
54H
Parallel I/F
bidirectional mode -
---
b0: Reverse Channel Transfer
(0: on 1:off)
b1 to b7: Reserved
00H 00H
55H I/f mode selection
0: Auto I/F selection
1: Parallel I/F
2: Serial I/F
00H
(Auto)
00H
(Auto)
56H
Auto I/F wait time
setting
10: 10 sec.
30: 30 sec.
00: 10 sec. (same as default)
00H
(10 sec.)
00H
(10 sec.)
Table 7-13. EEPROM Address Map (continued)
Address Explanation Setting
QPIT
Settings
Factory
Settings