User`s guide

Printing on Special Media
3-10
To load up to 30 ink jet cards, place them printable side
down, with the short edge leading into the feeder. Remove
the rear paper support guide and reinstall it backward,
sliding it forward to the edge of the cards.
10. Lower the output tray and slide out the output tray
extension.
11. Now follow the instructions in Chapters 1 or 2 to select the
correct
Paper Source, Paper Size, and other settings in
your printer software. Then send a print job.
◗ If you run out of paper while printing, reload the sheet
feeder and press the
Pause button to continue.
◗ If the ink smears on your document, set the thickness
lever to the + position and reprint; see page 3-7.
◗ If your margins are not where you like them, adjust
them in your application software. However, if the
problem seems to be with your paper’s loading
position, you can change it using the
Micro Adjust
buttons; see page 3-20 for instructions.
rear paper
support guide
Note:
Make sure that paper
isn’t loaded in the manual
feeder at the top of the
printer before sending
your print job. If paper is
loaded in the manual
feeder, the printer will
print on it instead of the
paper in the built-in sheet
feeder.
media.fm5 Page 10 Friday, May 9, 1997 1:48 PM