User`s guide

62 Presenting Through a Wireless Network
9. Select
Internet Protocol and click the Properties button. You
see this screen:
10. If your access point uses DHCP, select
Obtain an IP address
automatically
. Otherwise select Use the following IP address
and enter the required information:
■ IP address: Type in the IP address you want to assign to the
computer. It must be formatted like other addresses on the
network. The last section must be unique.
■ Subnet mask: For example: 255.255.255.000, but this
depends on how your network is set up.
■ Default gateway: Enter the IP address that was assigned to
the access point when it was set up.
11. When you’re done, click
OK.
12. Click the
Wireless Networks tab.
(If you don’t see this tab, you may need to enable your wireless
card or adapter by clicking
Configure to access the device
settings; then follow any instructions on the screen to enable the
device.)
note
For specific details about
your network, please consult
your network administrator.
note
If you don’t know your
gateway or access point
address, see page 64.