User`s guide

136 Managing Projectors
Connecting to a Wired Network
Follow these steps to connect the projector to your network and
configure it with an IP address.
1. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the
LAN port on the projector. See page 53.
2. Point the remote control at the projector and press the P
Power
button.
3. Press the
EasyMP button on the remote control to select EasyMP
as the source.
4. Press the
Menu button on the remote control, select the
Network menu, then press Enter.
5. Choose
To Network Configuration and press Enter.
6. Choose
Wired LAN and press Enter.
You see the following screen:
7. Do one of the following:
■ If your network assigns addresses automatically, turn on the
DHCP setting.