User`s guide

158 Maintaining the Projector
5. Hold the lamp as shown and pull it straight out.
6. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.)
7. Once the lamp is fully inserted, tighten its screws.
8. Replace the lamp cover, then tighten its screw.
9. Slide out the air filter on the bottom of the projector and
remove it.
10. Slide in the new air filter until it clicks in place.
11. Reset the lamp timer as described in the next section.
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.