Service manual

PhotoPC 2100Z Revision B
Product Description Interface Specifications 27
LCD SHOOTING

Old method
1.
Turn on camera, then strat shooting in one minutes interval.
2.
No zoom operation, and 50% flash emission.
3.
Repeat Step1 and 2.

New method
1.
Turn on camera and leaves for 30 seconds, and start shooting 30
seconds interval for 10 times.
2.
Shoot and zoom operation between wide end and telescopic end,
and 50% flash emission.
3.
Turn off the camera for 10 minutes and more after 10 times.
4.
Repeat Step 1 to 3.
VF SHOOTING

Continuous shooting

No zoom operation

Flash is off.
PLAYBACK
Frame forwarding interval one minutes.
1.4.7 Power Saving Specifications
This section provides the power saving specifications for PhotoPC 2100Z.
1.4.7.1 Shooting Mode
BATTERY

Power saving mode 1 (The camera enters this mode after 2 minutes of no
operation)
Power saving mode 1 is entered after displaying icon animation.
Restoration condition: The camera is restored to the normal status by one of the
following events:

The Shutter Button is pressed.

The Playback Button is pressed.

One of the buttons (including the DPOF button) on the back is pressed.

The W/T Button is pressed.

The communication cable is connected.
When the communication cable is connected, the camera enters the
communication mode.
NOTE:
In the case where the camera enters the power saving mode from flash off
status, the flash will not be charged at restoration from power saving mode.