Instruction Manual

The printer loads more than one sheet at a time.
Cause What to do
The paper may have been
loaded too deeply into the
printer.
Remove the paper and gently reinsert
it straight up and down into the
printer.
Too many sheets are loaded
in the sheet feeder.
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Load paper only up to the arrow
mark on the left edge guide.
The edge guides are not set
correctly.
Adjust the guides against the stack of
paper. See “Loading Plain Paper” on
page 3-2.
The paper thickness lever or
the adjust lever position may
not be set correctly.
Make sure the paper thickness lever
and adjust lever positions are set
correctly. See page 4-2.
The paper is too thin. Make sure the paper meets the paper
requirements for this printer. See
“Paper” in the Appendix.
Ejected paper is wrinkled.
Cause What to do
The paper is too thin or damp. Do not store your paper in a damp or
humid environment. Store paper in its
original packaging.
6
Troubleshooting
R
Hudson++ Ref. Guide
Rev.d
A5 size Chapter 6
04-30-98 DR, pass 3
Troubleshooting
6-13