Camcorder User Manual

Installing Software and Connecting
9-9
NOTE
◗
If you’re using Windows 98 or Windows 2000 and you see a
New Hardware screen, follow the instructions below.
◗
If your iMac is running OS 8.1, you’ll need to upgrade your
operating system to OS 8.5.1, or later, before connecting to
your camera using the USB cable.
Follow these steps:
1
Locate the USB cable that came with the camera.
2
Plug the connector on the USB cable into the USB port
on your computer, or into a port on a USB hub.
NOTE
Although you can use a USB hub, it’s recommended that you
connect the camera directly to the computer’s USB port.
3
Open the connector cover on the side of the camera.
Then insert the connector on the other end of the USB
cable into the camera’s USB interface port.
4
Turn on your computer, then turn on the camera and
turn the camera dial to
.
Installing Your Windows USB Driver
If you’re connecting to a Windows 98 or Windows 2000
system with a USB port, complete the steps starting on
page 9-2 to install your software. The first time you connect
the camera to your computer with your USB cable, you’ll see
the Add New Hardware Wizard (Windows 98) or the Found
New Hardware Wizard (Windows 2000).
Capella.book Page 9 Thursday, April 20, 2000 4:21 PM