Camcorder User Manual

Operating the Camera From Your Computer
13-5
You can use the
Quality
,
Flash
,
Self Timer
, and
Monochrome
controls on the screen to adjust these
settings just as you would by using the buttons or LCD
menus on the camera.
6
When your shot is ready, click
Take a Picture
. The
image is captured and processed.
7
Click
Close
when you’re finished taking pictures from
your computer.
The Auto-Stop Timer shuts off the live preview after one
minute to save battery power. You can set the timer from
30 seconds to 5 minutes.
NOTE
If you have an external flash unit attached and have changed the
flash setting to Ext Flash, you can’t change the flash mode. To
change the setting back so you can use the camera’s built-in
flash, see page B-5.
Adjusting Camera Settings From
Your Computer
You can use either Image Expert or EPSON Photo!3 to
change the following camera settings:
◗ Time
◗ Date
◗ Camera Description (ID)
◗ Connection Port
◗ Connection Speed
Changing Settings With Image Expert
You can change settings in Image Expert while you’re
viewing pictures in the camera. Follow these steps:
1
Connect the camera to your computer as described in
Chapter 9.
2
Turn the camera dial to , then turn on your camera
and your computer system.
Capella.book Page 5 Thursday, April 20, 2000 4:21 PM