Camcorder User Manual

Presenting Your Photos
14-9
NOTE
◗
The entire screen is captured, not just the active
window. Make sure you maximize your presentation
before you capture it. If you set your application to
“slide show” mode (or the equivalent) you can capture
just the image you want, without menus and other
screen elements.
◗
Presentations using large fonts (at least 18 points) work
best.
7
Press the hot key combination you selected. Your screen
capture is assigned a file name and saved to the folder
that you specified.
You can make as many screen captures as you’d like;
simply open each file you want to capture and press your
screen capture key combination again.
8
When you’re finished, close your application and click
the
Stop
button on the Screen Capture dialog box. The
key combination you selected is erased.
To convert your screen captures for uploading, follow the
instructions on page 14-2. Then follow the instructions on
page 14-6 to upload the screens to the camera.
Capturing Macintosh Screens
EPSON File Converter for the Macintosh does not have a
screen capture feature. However, you can make screen
captures using your Macintosh system software, then use
EPSON File Converter to convert the screen captures so you
can upload them to your camera.
The procedure may differ slightly, depending on your
Macintosh. See your computer manual for more
information.
Follow these steps:
1
Start your application and open the file for the image
you want to capture.
2
Press the J,
Shift
, and
3
keys on your computer
keyboard at the same time. Your Macintosh names and
saves the screen shot on your hard drive (not in a folder).
You can make as many screen shots as you’d like; simply
repeat this step.
Capella.book Page 9 Thursday, April 20, 2000 4:21 PM