Camcorder User Manual

Capturing Video Clips and Special Shots
3-3
You can’t use the flash for continuous shooting, so make sure
you have adequate lighting for your pictures. Also, you can’t
select the HyPict or Tiff image quality settings.
NOTE
If you want to adjust any camera settings, such as white balance,
sensitivity, or macro mode, turn the camera dial to to see the
View menu and adjust the settings, then turn the camera dial
back to . See Chapters 4 and 5 for details.
Follow these steps to take a sequence of pictures:
1
Make sure you are at least 20 inches (50 cm) away from
your subject.
2
Turn the camera dial to . Wait until the photo
capture light stops flashing and remains a steady green.
3
Press the button under
Mode Change
to change to
Continuous Shooting mode.
You see a preview of your picture on the LCD screen
with a red frame around it.
CONTINUOUS
appears on
the screen.
4
Center your subject in the red frame.
5
Press and hold the shutter button all the way down.
If the camera’s shutter sound is enabled, the camera
clicks as it captures each picture. (See page 7-2 to enable
camera sounds.)
6
When the camera has captured a sequence of pictures,
the green photo capture light turns off. Release the
shutter button.
NOTE
If you continue to hold down the shutter button after the first
sequence of pictures, the camera will pause to process the
images and then take a second sequence. The camera will
continue to take pictures until the memory card is full.
Capella.book Page 3 Thursday, April 20, 2000 4:21 PM