Personal Computer User Manual

After DISKCOPY copies the data from memory to the

target diskette, the screen prompts you to insert the source

diskette again to copy the remaining data to the computer’s

memory (if necessary). Insert the source diskette into

drive A and press any key.

8. After DISKCOPY copies the rest of the source diskette’s

data to the computer’s memory, the screen prompts you to

insert the target diskette again to copy the remaining data

from memory to it. Insert the target diskette and press any

key. When the copy is complete, you see this message:

Copy another diskette (Y/N)?

9. Press Y to copy another diskette or N to return to the

MS-DOS command prompt.

Using DISKCOPY with two diskette drives

If you have two diskette drives, follow these steps to copy a

diskette:

Make sure the diskette you want to copy is write-protected.

(See Chapter 3 for instructions.)

If you don’t have a hard disk, insert your Startup diskette

into drive A.

3. At the MS-DOS command prompt, type the following and

press

Enter:

DISKCOPY A: B:

MS-DOS prompts you to insert your diskettes:

Insert SOURCE diskette in drive A:

Insert TARGET diskette in drive B:

Press any key to continue . . .

Using MS-DOS with Your Equity 386SX

4-33