Personal Computer User Manual

When Auto speed is enabled, the computer automatically

switches to low speed whenever it needs to access a diskette

drive. It runs at high speed for all other operations.

There are different types of copy-protected programs.

Depending on the type you have, you may or may not want to

enable the Auto speed function. Follow these guidelines:

If you are using a copy-protected program that can run only

on a diskette or that requires a key disk, try to start the

program on high speed. If this works, you do not need to

enable the Auto speed function.

If you can’t load the program on high, enable Auto speed.

D If you are using a copy-protected program that does not

require a key disk but requires a special procedure to install

the program on a hard disk, set the

CPU SPEED

switch on

the front panel to LOW while you are installing the

program. Once it is installed, set the switch to HIGH, where

you should be able to leave it while you load and run the

program.

If this does not work, try loading the program at low speed

and then switch to high to run it. Do not enable the Auto

speed function.

Follow these steps to change the Auto speed setting:

1. At the main Setup menu, highlight Auto speed and

press

Enter.

The current status appears:

Auto speed disabled

** SAVE SETTING **

If the displayed setting is correct, press

1‘

to return to the

main Setup menu.

Running the

Setup

Program

2-13