User guide

Caution
To avoid generating static electricity and damaging the
memory chips, ground yourself by touching the metal
surface on the inside of the computer’s back panel. Then
remain as stationary as possible while you install them.
3. Remove the memory chips from their package and inspect
each one. The pins should point inward at slightly less than
a 90° angle.
If any of the pins are bent or crooked, straighten them gently
with your fingers or with small tweezers to align them with
the other pins. Be careful when you do this; the pins are
fragile and can break off easily.
4. Position one of the ZIP chips over the first empty socket (U2)
as shown below, aligning the pins on the chip with the
holes in the socket.
5. Gently press the chip halfway into the socket (to make sure
it is correctly aligned). If the chip does not go in smoothly,
remove it and try again.
4-22
Installing and Removing Options