User Manual

EPSON Stylus Color 440/640/740 Revision A
Chapter 4 Disassembly and Assembly 117
4.2.4.5 Removing the PF Motor Assembly
[For Stylus Color 740]
1. Remove the housing.(Refer to Section 4.2.1.)
2. Remove the absorber tray assembly ;A. (Refer to Section 4.2.4.2.)
3. Remove the following gears located on the left side of the printer
mechanism.
Gear 67.2 (Remove the ring with tweezers or a (-) driver. After
the ring is removed, if you try to remove the gear 67.2 by holding
its edge, the gear may break. So, try to remove it while holding
the whole gear, slightly pulling it toward you.)
Combination gear 8.8,21.6
Combination gear 8,14.4
Gear 36
4. Remove 2 hexagon nuts and remove the PF motor assembly.
Figure 4-13.
Removing the PF Motor Assembly for Stylus Color 740
CHECK
PO INT
When disassembling the PF motor assembly, pull the
motor assembly out of the frame a little bit and remove
it, sliding it into a larger hole in the frame. (See Figure
4-13.)
Be careful of the direction of the wires from the PF
motor assembly.
Do not damage or mar the grooves in the gears during
the disassembly and assembly.
C-Ring
PR M otor Assem bly
H exagon N ut
C om pression Spring 0.9
G ear 67.2
C om bination S
p
rin
g
8.8,21.6
G ear 36
C om bination G ear8,14.4
G ear 34