User`s guide

120 Fine-Tuning the Projector
■ Projection
Select Front (to project from the front of a screen and right side
up),
Front/Ceiling (when the projector is mounted upside-down
from the ceiling),
Rear (to project from behind onto a
transparent screen), or
Rear/Ceiling (to project from behind onto
a transparent screen when the projector is mounted upside-down
from the ceiling).
■ Operation
Enable Direct Power ON if you want to have the projector start
when the power cable is connected (without pressing the
Power
button). Enable Sleep Mode if you want to have the projector
turn off automatically if it is idle (and no signal is received) for 30
minutes.
■ Standby Mode
Select Network ON to enable the projector to be monitored over
a network when it is in standby mode (the power light is orange).
■ Link 21L
Enable this setting if you want to be able to control the projector
from a USB-connected computer.
■ Language
Select from nine languages to be used for the projector menus.
note
If Direct Power ON is
enabled, the power cable is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
Canada User's Guide.book Page 120 Friday, September 3, 2004 3:49 PM