User`s guide

Maintaining the Projector 147
4. Turn the projector over. Press in on the tabs and lift up the lamp
cover.
5. Loosen the two screws holding the lamp in place (you don’t need
to remove them).
6. Hold the lamp as shown and pull it straight out.
7. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.)
Loosen, but don’t
remove these screws
warning
This product includes a
lamp component that
contains mercury (Hg).
Please consult your state and
local regulations regarding
proper disposal and do not
put in the trash.
Canada User's Guide.book Page 147 Friday, September 3, 2004 3:49 PM