User`s guide

18 Displaying and Adjusting the Image
Projecting the Image
Make sure your projector and other equipment are set up as described
on page 37. Then follow the instructions below to start the projector
and display an image.
Turning On the Projector
Turn on any connected computer or video equipment before starting
the projector so it can automatically detect and display the image
source. If you turn on the projector first, or have multiple pieces of
connected equipment, you may have to select the image source
manually (see page 19).
Follow these steps to turn on the projector:
1. Remove the lens cap.
2. Plug one end of the power cable into the projector, and the other
end into an electrical outlet.
The
Power light comes on.
note
To shut down the projector,
see page 26. Shutting down
the projector correctly
prevents premature lamp
failure and possible damage
from overheating.
Power light
Canada User's Guide.book Page 18 Friday, September 3, 2004 3:49 PM