User`s guide

Displaying and Adjusting the Image 27
3. Press the PPower button again. The lamp is turned off and the
Power light flashes orange for about 20 seconds as the projector
cools down. After the projector has cooled, the projector beeps
twice, the orange light stays on, and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the P
Power button.
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Replace the lens cap and unplug the power cord.
Using the Direct Power On Function
The Direct Power On function enables faster setup. The projector will
start up automatically when you plug it in; you won’t have to press the
P
Power button.
Follow these steps to enable Direct Power On:
1. Press the
Menu button on the remote control and select the
Extended menu.
2. Choose
Operation and press Enter.
3. Choose
Direct Power On and press Enter.
4. Highlight
On and press Enter.
5. Press
Esc or Menu to exit.
The setting will take effect the next time you plug in the projector.
caution
Turn the projector off when
not in use. Continuous
24-hour-a-day use may
reduce the projector’s
overall life.
note
If a power outage occurs
when Direct Power On is
enabled and the projector is
plugged in, the projector will
start when the power is
restored.
Canada User's Guide.book Page 27 Friday, September 3, 2004 3:49 PM