Owner manual

Using the Projector’s Menus 135
Controlling Multiple Projectors
If you’re using more than one projector for your presentation, you can
use the projector’s ID system to switch between them using a single
remote control. To do this, you need to set a different ID for each
projector. During the presentation, it’s easy to change the remote
control’s ID to match that of the projector you want to use. When
you want to switch, simply change the remote control’s ID to match
that of your second projector.
Setting the Projector ID
The projector’s default ID is 1. Follow these steps to change it:
1. Press the
Menu button on the remote control.
You see the projector’s menu screen.
2. Select the
Advanced2 menu and press Enter. Then highlight
Projector ID and press Enter.
3. Press the right or left side of the pointer button to increase or
decrease the ID value.
4. Press
Enter to set the value.
5. When done, press
ESC to exit the menu system.
note
By default, the remote
control’s ID is set to zero,
which allows it to control
any projector. If you want to
control multiple projectors
simultaneously, and you
don’t want to switch
between them (each
projector would need its own
screen), you can leave the
remote control’s ID set to
zero. In this situation, you
would not need to change
the projector’s ID.
Brightness Control
Brightness Control
High
High
Low
Low
:
Video
Video
Audio
Audio
Setting
Setting
User's Logo
User's Logo
Advanced1
Advanced1
About
About
Reset All
Reset All
Projector ID
Projector ID
Network
Network
Reset
Reset
Execute
Execute
: 1
: 1
[Menu]: Exit
[Menu]: Exit
Effect
Effect
Advanced2
Advanced2
COM Port
COM Port
BNC Sync Termination
BNC Sync Termination
:
ON
ON
OFF
OFF
:
Set
Set
Set
Set
RS-232C
RS-232C
USB
USB
[ / ]: Select
[ / ]: Select
[ ESC ]: Return
[ ESC ]: Return
[ ]: Set
[ ]: Set
Auto setup
Auto setup
:
OFF
OFF
:
ON
ON