Owner manual

Managing Projectors 143

■ To enter numbers using the remote control, press the Num

button until it lights, then use the number keypad shown

below.

■ To change the network addresses from the projector’s control

panel, press the right and left arrow buttons to select the part

of the address you want to enter, then use the up and down

arrow buttons to increase or decrease the numeric value.

When you finish changing an address in the network menu, press

the

Enter button (on the remote control) or the Auto/Enter

button (on the projector). This stores the value.

5. When done making all necessary changes, press

ESC to exit the

menu system.

Num button

Zero

Increase

decrease

the value

Select the

part of the

address to

change