Owner manual

26 Displaying and Adjusting the Image

Adjusting the Image Shape

In most cases, you can maintain a square or rectangular image by

placing the projector directly in front of the center of the screen with

the base of the lens level with the bottom of the screen.

Even if the projector is slightly tilted (within a range of 40° up or

down), the projector has an automatic keystone correction function

that detects and corrects vertical keystone distortion.

It takes about one second after projection starts for the image to be

corrected. During this time, a vertical keystone correction gauge

appears on the screen.

If your image is still distorted, you can correct it using either of these

methods:

■ If the image has two parallel sides but is wider on one side (top,

bottom, left, or right), you can correct it using the

Keystone keys

on the projector’s control panel or the projector’s Keystone menu

(see “Using Keystone Correction” on page 27).

■ If the image has no parallel sides, you can adjust its shape using

Quick Corner

™

(see page 37).

You cannot use both keystone correction and Quick Corner at the

same time.

Corrected imageProjector tilted up Projector tilted down

Quick Corner correction

Keystone correction