Owner manual

Connecting to Computers, Cameras, and Other Equipment 53
Connecting to the BNC Connectors
1. Obtain a commercially available standard BNC cable.
2. Plug the BNC connectors into the projector’s
B/Cb/Pb, G/Y, and
R/Cr/Pr connectors as shown below. Depending on your
computer’s video card, you may have to connect to the projector’s
V Sync and H/C Sync connectors too. (See your computer
documentation for more information.)
3. Plug the connectors on the other end of the cable into the BNC
video out connectors on your computer.
4. Optionally, you can connect an external monitor (see page 57),
play sound through the projector (see page 65), or connect a USB
cable to use the remote control as a mouse (see page 56).
5. When you’ve finished making all necessary connections, see
Chapter 1 for instructions on turning on the projector and
adjusting the image. Once the projector is turned on, be sure to:
■ Enter the projector’s Setting menu, then make sure the BNC
Input is set to
Analog-RGB. See page 137.
■ After exiting the menu system, press the BNC button on
the remote control or repeatedly press the
Video/BNC button
on the projector’s control panel to select the correct source.
BNC (Analog-RGB) should appear on the screen.
BNC cable
R/Cr/Pr
G/Y
B/Cb/Pb