Owner manual

Presenting Through a Wireless Network 75
5. Check your wireless card or adapter’s device settings. (Depending
on the type of card or adapter you’re using, some of the settings
may be different than those listed here.)
■ Set the network type to 802.11 Ad Hoc.
■ Set the SSID to match the name you assigned to the
projector’s ESSID—for example,
CONF ROOM. (If your
network card uses channel mode instead, set the correct
channel, 1 to 11, so it matches that of the projector.)
■ Make sure encryption is Disabled.
6. Click the
General tab and make sure that your wireless card or
adapter is enabled.
7. When done making the settings, click
OK to close the wireless
card or adapter’s -properties dialog box.
Now you’re ready to connect to the projector. See “Projecting
Wirelessly” on page 89.
Setting Up Your Macintosh for Ad Hoc Mode
Your AirPort software is automatically configured to allow your
Macintosh to detect both computer-to-computer (Ad Hoc) and
Access Point networks. Typically, you only need to select your
projector’s ESSID from the AirPort status menu on the Macintosh
menu bar.
If you’re having problems detecting the projector, follow these steps:
1. From the Apple pull-down menu, select
System Preferences.
Then double-click the
Network icon. You see the Network
settings window.