Owner manual

76 Presenting Through a Wireless Network
2. Make sure Location is set to
Automatic.
3. Select
Network Port Configurations in the Show pull-down
menu.
4. Under Port Configurations, select
AirPort.
5. Click
Apply Now. Then close the window.
6. Click the AirPort icon on the menu bar at the top of the
Macintosh desktop. You see the AirPort status menu:
7. Check to make sure AirPort is turned on.
8. Select your projector’s ESSID.
note:
If you don’t need the other
network ports, disable them
by deselecting their check
boxes. If more than one
network port is enabled, the
projector software warns you
to turn off AirPort when you
first connect the projector.
Disregard this message.
Select
Automatic
Select Network Port
Configurations
then select AirPort