Owner manual

78 Presenting Through a Wireless Network
Make sure
Access point mode is selected, as shown. If not,
use the button on the remote control to highlight the
checkbox next to
Access point mode, then press Enter
to select it.
3. Use the button to highlight
Advanced (next to Access point
mode
), then press Enter to select it.
You see this screen:
4. Make sure the projector has a unique name, so you can identify it
when connecting to it from your computer.
If you need to rename it, highlight the
Clear button next to
Projector name, then press Enter on the remote control to clear
the text box. Then highlight the text box and press
Enter. The
cursor turns green to indicate you are in input mode. Tilt the
button up to select individual letters in alphabetical order, or
down to select letters in reverse order; then tilt the button to
the right to move to the next character position. When done
typing the new name, press
Enter.
note
If you want to enter a blank
space, use the space character
that comes before the capital
letter A.
If you want to enter
numbers, press the
Num
button on the remote
control. The button lights up
to indicate that the numeric
keypad mode is active. Press
the
Num button again to
exit numeric keypad mode.