User`s guide

R4CB860

html.bk Rev. F

TIPS.FM A5 size

10/19/04

Proof Sign-off:

KOW N.Mizuno H.Tomizawa

T.Takahashi

NOC K. Lee

Note:

In the following procedure, we assume that the MAC address of your

network interface is 00:00:48:93:00:00 (hexadecimal), and that the IP

address which you will be assigning is 192.168.100.201 (decimal).

Substitute your values for these addresses when you type in the

commands.

1. From the command line, type:

Example: arp -s 192.168.100.201 00-00-48-93-00-00

2. Execute the ping command to set the IP address by pinging it:

Example: ping 192.168.100.201

3. The network interface should now respond to the ping. If it

does not, you may have incorrectly typed the MAC address

or the IP address in the arp -s command. Double-check and

try again. If none of these actions are effective, re-initialize the

network interface and try again.

4. Print a status sheet to check whether the new IP address has

been assigned to the network interface.

Note:

When the IP address is set by the ping command, the subnet mask

is automatically changed by the class of the IP address. To change

the subnet mask and the default gateway according to your network

environment, use EpsonNet Config on Windows operating systems

or EpsonNet Config in Macintosh.

Instructions on Using a Dial-Up Router

This section describes instructions on using a dial-up router.