Specifications

PictureMate Flash (PM 280)
8/06 PictureMate Flash (PM 280) - 13
4. Insert the battery as shown until it clicks into place.
Charging the Battery
After you install the battery, you need to charge it by
connecting the AC adapter and plugging in the printer.
The power light flashes during charging when PictureMate is
off. It takes about 2 hours to fully charge the battery when
PictureMate is off. It takes longer when you use PictureMate
while it is charging.
The power light turns off when the battery is fully charged (if
PictureMate is turned off).
The following battery status icons appear in the upper right
corner of the photo viewer screen:
Note: If you are running PictureMate with the battery, the printer
turns off automatically after 15 minutes if it is not being used (unless
PictureMate is connected to a computer and a memory card is
inserted). Press the On
button to turn it back on.
Removing the Battery
If there is a problem with your battery, or you want to replace
it with one that is already charged, you need to remove the
battery.
1. Make sure PictureMate is turned off.
2. Release the latch and remove the battery.
3. Replace the battery cover.
Checking the Print Pack Status
You can check the status of your Print Pack on the
PictureMate photo viewer screen.
1. Press
Menu.
2. Press or to highlight
Check Print Pack and press OK.
You see the status displayed on the photo viewer screen:
3. Press
OK to exit.
Note: If the screen displays a Print Pack low message, you should
buy a new PictureMate 200 Series Print Pack.
Battery
status icon
Low
Almost out
Charging
2/3 full
1/3 full
– 100%
– 50%