Specifications

Epson ESC/P 2 and FX Emulations
This section lists the control codes supported in the ESC/P 2 and FX
emulations. Some ESC/P 2 and FX printer codes are not available, either
because the functions are not required (such as draft printing) or are not
possible because of the different technologies used in these printers.
If a command has no parameters, it is merely listed. If it has parameters,
they are explained. The parameters are indicated by lowercase italicized
letters, usually n. The examples below show how the parameters are
indicated.
ESC @ is a command with no parameters.
ESC U 1/0 is a command that uses 1 to turn the feature on and 0 to turn it
Off.
ESC K n1 n2 is a command with two parameters.
ESC D nn is a command with a variable number of parameters.
Note:
Although additional commands not shown on thefllowkg list are supported,
they are not recommended and are provided only for compatibr?ity with older
printers.
Epson ESC/P 2 emulation
FU?lction
Gmmand
General operation
Initialize printer ESC @
Control paper
ESC EM n
ldi/ejdg
Paper feeding
carriage- CR
Form feed FF
Line feed LF
Command Summary B-17