User`s guide

Reconnecting the Diskette Drive Cables

Refer to the illustration below while you follow the steps in this

section to reconnect cables to the diskette drive.

red wire

Locate the connector you will use on the diskette drive cable.

Identify pin 1 on the drive and align the connector so that

the red wire is at pin 1. Push in the connector.

Locate the power supply cable with the small connector.

Position the power supply cable connector so that the holes

fit over all the pins and the red wire aligns with pin 1 on

the drive’s connector. Then push in the connector.

If you have finished installing or removing drives, replace

the computer’s cover; see “Replacing the Cover” in Chapter

for instructions. Then see “Running SETUP” in Chapter 2

for instructions on defining your new drive configuration.

Installing and Removing Drives in the Slimline Computer

5-11