User`s guide

3. Remove the screws securing the hard disk drive to the
bracket and slide the drive out of the bracket.
4. If you removed the only IDE device connected to the
interface the device used, you may want to disconnect the
device cable from its interface on the system board and
remove it from the computer.
5. Replace the bracket following the instructions under
“Replacing the Bracket in the Computer.”
6. If you have finished installing or removing drives, replace
the computer’s cover; see “Replacing the Cover” in
Chapter 4 for instructions. Then see “Running SETUP” in
Chapter 2 for instructions on defining your new drive
configuration.
Installing a Drive in an External Drive Bay
Your system includes two externally accessible drive bays.
Using these bays, you can install any type of drive, including
internal hard disk drives.
If you are installing a hard disk drive or another IDE device,
be sure its jumper(s) are set correctly for your configuration;
see “Setting the IDE Device Jumpers and Locating Pin 1” in
Chapters 5 and 6 for instructions.
Before you can install a drive in one of the external bays, you
must remove the mounting bracket containing the diskette
drive (and possibly a hard disk drive). Follow the instructions
under “Removing the Drive Mounting Bracket.” (You can
remove the bracket and drives without disconnecting the drive
cables.)
Installing and Removing Drives in the Slimline Computer 5-13