User`s guide

Remove the four screws securing the drive to the drive bay.
There are two screws on each side of the drive.
Slide the drive out the back of the bay
If you removed the only IDE device connected to the
interface the device used, you may want to disconnect the
device cable from the interface on the system board and
remove it from the computer.
If you have finished installing or removing drives, replace
the computer’s cover; see “Replacing the Cover” in Chapter
4 for instructions. Then see “Running SETUP” in Chapter 2
for instructions on defining your new drive configuration.
Installing and Removing Drives in the Tower Computer
6-9