User`s guide

The application program does not start.
Check that you are following the correct procedure for starting
the program and that it is installed correctly. If you need help
on software that came with your configured computer, see the
User's Digest for technical support information. If you
purchased the software separately, contact your software
manufacturer.
The application program cannot read from or write to the
hard disk drive.
If you have enabled the Hard Disk Standby Timer
option in SETUP, your application may be timing out during
the few seconds when the hard disk drive returns to its full
speed. Disable this option in SETUP as described under
“Setting the Green PC Features” in Chapter 2.
Your application has locked the computer, making if
unresponsive to keyboard commands.
Reset the computer and try again. If resetting the computer
does not help, turn it off, wait 20 seconds, then turn it on again.
Some software, like OS/ 2, UNIX, or NetWare, needs at least
8MB to 16MB of RAM to work correctly. Check your software
documentation for the minimum memory requirements. If
necessary, add more memory as described under “Installing
Memory Modules (SIMMs)” in Chapter 4.
7-14 Troubleshooting