User`s guide

The Transfer mode option selects the method for
transferring data between the hard disk and system memory. If
this option is not automatically set, you can select Standard
(thedefault), Fast P1O1, Fast P102, or Fast P103.
The LBA Mode Control option enables or disables ISA
logical block address (LBA) mode control for each drive. If this
option is not detected automatically, and your drive supports
LBA mode control, select Enabled. Many drives larger than
528MB support LBA mode control, but some older drives do
not; check the drive documentation.
The 32 Bit I/O option sets the I/O transfer rate for data
read from the disk. If your drive supports 32-bit I/O transfers,
select Enabled; the default setting is Disabled (16-bit
transfers).
Defining your own drive parameters
If the parameters for your hard disk do not match the
parameters detected by the auto-sensing feature, you must
define your own drive parameters. Follow these steps:
1. Move the cursor to Type and select User.
2. Type the values in each field that are appropriate for your
hard disk drive.
3. When you leave SETUP, make sure you save your changes.
Running SETUP and Installing Drivers 2-7