User`s guide

L
t
c
c
L
* Default setting
The Integrated Peripherals optionsaredescribedin
the table below.
Integrated peripherals options
Option
COM 1
COM 2
LPT port
Settings Description
3F8, IRQ 4 * (COM1) Assign the address for the built-in
2F8, IRQ 3 * (COM2) primary and secondary serial
338, IRQ 4 ports: the Auto setting detects
238, IRQ 3 any optional ports you may have
3E8, IRQ 4 installed and sets the built-in ports
2E8, IRQ 3 automatically based on the
2E8, IRQ 4 optional port settings to avoid
2E0, IRQ 3 conflicts (if no optional ports are
220, IRQ 4 installed, Auto sets the built-in
228, IRQ 3 ports to their default settings): the
Auto Disabled setting disables the
Disabled
port(s)
378, IRQ 7 * Assigns the address for the built-in
278, IRQ 7 parallel port: the Auto setting
3BC, IRQ 5 detects any optional ports you
378, IRQ 5 may have installed and sets the
278, IRQ 5 built-in port automatically based
3BC, IRQ 7 on the optional port settings to
Auto avoid conflicts (if no optional
Disabled ports are installed, Auto sets the
built-in port to the default setting):
select Disabled to disable the
port
LPT Mode
Standard
Bi-Directional*
ECP
Sets the parallel port mode to:
Unidirectional AT mode
Bidirectional
PS/2 mode
Extended Capabilities Port
mode
Diskette
controller
CMD
Enhance
Mode 3
Enabled *
Disabled
Enabled *
Disabled
Enables or disables the built-in
diskette drive controller
Enables or disables the CMD
driver that automatically checks
your drive’s IDE modes
Running SETUP and Installing Drivers 2-9