User`s guide

The table below describes the available options
Boot sequence option settings
Option
+
A: then C: *
C: then A:
+
C: only
* Default setting
Description
Loads operating system from drive A; if it isn’t
there, loads it from drive C (recommended
setting)
Loads operating system from drive C; if it isn’t
there, loads it from drive A
Loads operating system from drive C
Note
If you set Boot sequence to C: only, you will not be
able to start your system when there is a problem with your
hard disk drive.
If you set the Boot sequence option to C: only, you
should disable the Floppy check option so the system
doesn’t access the diskette drive during the startup procedure.
Disabling this option decreases the time needed to start the
system; the default setting is Enabled.
Selecting the Security Setup Options
When you select Security Setup from the Main Menu,
you see the Security Setup screen, which contains options that
allow you to set passwords and other security and anti-virus
options, as described below.
Running SETUP and Installing Drivers 2-13