User`s guide

Removing an Option Card

You may need to remove an option card to access components

on the main system board or if you no longer need it. Refer to

the illustrations for your computer and slot type under

“Installing an Option Card” as you follow these steps:

If you are removing a card from one of the half-length slots

in the slimline computer, first remove the slot cover

bracket. Then pull the card straight out of the slot.

If you are removing a card from the tower computer or from

one of the full-length slots in the slimline computer, remove

the retaining screw securing the option card to the

computer. Then pull the card straight out of the slot.

If you are not installing another option card, replace the

option slot cover, the slot cover bracket (if necessary), and

retaining screw(s).

Replace the computer’s cover; see “Replacing the Cover.”

Then see “Post-installation Procedures” for instructions on

configuring your computer without your option card.

Adding Video Memory

Your computer comes with 1MB of video memory. You can

increase your video memory to 2MB by installing two 512KB,

40-pin, SOJ flat pack video DRAM chips. Additional video

memory is useful for running graphics-intensive applications

or for supporting high resolutions with many colors.

Note that your video memory sockets may not look exactly like

the ones in the illustration. If you’re not sure how to install

video memory, contact your Authorized EPSON Servicer or the

EPSON Connection and ask for assistance.

4-22 Installing and Removing Options