User`s guide

Follow these steps to install video memory:
1. Locate the video memory sockets on the left side of the main
system board, as shown in the illustration under “Locating
the System Board Components." The sockets are labeled
U13 and U14.
2. If there are any option cards in your way, remove them; see
“Removing an Option Card” for instructions.
Caution
To avoid generating static electricity and damaging the
memory chips, ground yourself by touching the metal
surface on the inside of the computer’s back panel. Then
remain as stationary as possible while you install them.
3. Position the chip over the socket and align the notch in the
chip’s corner with the notch in the corner of the socket, as
shown below.
notches
/--c--Y
4. Gently press the chip into the socket; then push down firmly
on both ends to make sure it is well-seated.
Installing and Removing Options 4-23