User's Manual

The Cut Sheet Feeder

Testing the Printer in the Cut Sheet Feeder Mode

When you perform the cut sheet feeder self test, the printer counts

the number of lines on the page. As shown on the following page,

the number of lines counted is printed out at the bottom of the first

test page. This number is the default page-length setting. This

setting, however, can be overridden by software commands.

Running the self test is the same as when the cut sheet feeder mode

is off. The steps below are for a self test in draft mode.

Make sure that the printer is turned off and a stack of paper is in

the bin. Check that the cut sheet feeder mode is selected and the

paper release lever is pushed to the rear.

While holding down the

LINE FEED

button, turn on the printer.

(For LQ mode, press the

FORM FEED

button instead of the

LINE

FEED

button.)

Using the Printer Options

5-9