User's Manual

Interface Specifications
printer controller is reset to its power-up
state and the print buffer is cleared. This
level is normally HIGH; its pulse width
must be more than 50 microseconds at
the receiving terminal.
32 -
ERROR
OUT
This level becomes LOW when the
printer is:
1) in paper out state.
2) off line.
3) in error state.
33 -
GND - Same as for Pins 19-30.
34 - NC
-
Not used.
35 - -
OUT
Pulled up to 5V through 3.3 Kohm
resistance.
36 -
SLCT IN IN The DC1/DC3 code is valid only when
this signal is HIGH. (Internal fixing can
be carried out with Jumper J10. The
level of this signal is factory-set to
, LOW.)
8-10 Technical Specifications