User's Manual
Table Of Contents
- FRONT MATTER
- PRODUCT UPDATE NOTICE
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP THE PRINTER
- CHAP 2-PAPER HANDLING
- CHAP 3-USING THE PRINTER
- CHAP 4-SOFTWARE AND GRAPHICS
- CHAP 5-USING THE PRINTER OPTIONS
- CHAP 6-MAINTENANCE
- CHAP 7-TROUBLESHOOTING
- CHAP 8-TECHNICAL SPECIFICATIONS
- CHAP 9-COMMAND SUMMARY
- APPENDIX
- GLOSSARY
- INDEX
- QUICK REFERENCE
Commands Arranged by Topic
ESC p
Format:
ASCII code:
Decimal:
Hexadecimal:
Comments:
Turn Proportional Mode On/Off
ESC p n
27 112 n
1B 70 n
Turns proportional mode on and off.
The following values can be used for n:
1: Turns mode on.
0: Turns mode off.
The width of proportional characters varies from character to
character. Therefore, a narrow letter like i receives less space than a
wide letter like W. Proportional character widths are given in the
Appendix. This command overrides fixed cpi fonts. When
proportional is cancelled, the previously selected font is used.
Graphic characters are printed in fixed cpi only; proportional mode is
recommended for use with Roman and Sans Serif fonts only.
SI
Format:
ASCII code:
Decimal:
Hexadecimal:
Comments:
SI
15
0F
Select Condensed Mode
Prints characters at about 60 percent of their normal width. For
example, the condensed 10 cpi mode has 17 characters per inch.
Condensed mode cannot be combined with 15 cpi. Condensed can be
turned on and off by SelecType, the SI command, or DIP switch 1-6.
Command Summary
9-25