User's Manual

Controller Problems
You see a controller error for the drive controllers, the video
controller, or the I/O port controllers when you start your
system.
The indicated controller on your system board may be faulty.
If you have an option card with a controller that will work with
your device, you can install it and change the jumper settings
on the system board to disable the built-in controller. You can
then continue to use your system until it is convenient for you
to have it serviced.
If the error message refers to your diskette drive or hard disk
drive controllers, make sure the jumpers for these devices are
set to enabled. See Chapter 3.
Internal Battery Problems
The screen displays an error message prompting you to run
SETUP when you start your system, or your system displays
the incorrect time and date
If your system has not been used for an extended period of
time, your internal NiCad backup battery may be discharged.
First, run SETUP to enter the correct time and date. (You may
also need to re-enter your computer’s configuration
information.) See Chapter 2 for instructions. Then, keep your
system running for several hours to recharge the NiCad battery.
5-12 Troubleshooting