User`s guide

Entering or changing passwords
To specify a User password, you must first specify a Supervisor
password. Follow these steps to enter or change a password:
1. Select Set supervisor Password and press Enter.
2. You see a Set Supervisor Password window. Type a
password of up to seven characters and press Enter.
3. Type the same password a second time and press Enter. You
see a message that your change has been saved.
4. Press the spacebar. The Supervisor Password option now
displays Enabled.
To set a User password, select the set User Password
option as you follow the steps above.
Deleting passwords
To delete your passwords, follow these steps:
1. Set the Password on Boot option to Disabled.
2. Select set User Password and press Enter.
3. Delete the User password by pressing Enter for both the
password field and the confirmation field. Don’t type any
characters in these fields.
4. Delete the Supervisor password the same way.
Note
If you set both a User and Supervisor password, you must delete
the User password before you can access the Supervisor
password option.
B-14 Running SETUP and Installing Drivers