Operation Manual

Operational Problems
The Ready light does not turn on
Cause What to do
The power cord may not be properly plugged into the
electrical outlet.
Turn off the printer, check the power cord connections between
the printer and the electrical outlet, then turn the printer back on.
The electrical outlet may be controlled by an outside
switch or an automatic timer.
Make sure that the switch is turned on or plug another electrical
device into the outlet to check whether the outlet is operating
properly.
The printer is in the sleep mode (the Wake Up/Sleep
button lights) or in the power off mode (the Wake Up/
Sleep button blinks).
Press the Wake Up/Sleep button to return the printer to ready
status.
The printer does not turn off
Cause What to do
The printer is in the power off mode (the Wake Up/Sleep
button blinks).
Wait for a while. The printer turns off in approximately two
minutes.
To not enter the power off mode, set Power Off Timer to Off in
Energy Saver Menu on the control panel.
The printer does not print (Ready light off)
Cause What to do
The printer is offline.
Press the Start/Stop button once to switch the printer to ready
status. Make sure that the Ready light turns on.
Some error may have occurred. Check the LCD panel to see if an error message appears.
The printer is in the power off mode (the Wake Up/Sleep
button blinks).
Press the Wake Up/Sleep button to return the printer to ready
status.
To not enter the power off mode, set Power Off Timer to Off in
Energy Saver Menu on the control panel.
Epson AcuLaser C9300 Series User's Guide
Troubleshooting 155