Operation Manual

Chapter 4

Replacing Consumable Products/Maintenance Parts

Precautions During Replacement

Always observe the following handling precautions when replacing consumable products or

maintenance parts:

For details about replacement, see the instructions that come with the consumable products or

maintenance parts.

Warning:

❏ Be careful not to touch the fuser, which is marked CAUTION, or the surrounding areas. If the

printer has been in use, the fuser and surrounding areas may be very hot.

❏ Do not dispose of used consumable products or maintenance parts in fire, as they may explode

and cause injury. Dispose of them according to local regulations.

❏ Provide enough space for the replacement procedure. You will have to open some parts (such as

the printer cover) of the printer when you are replacing consumable products or maintenance

parts.

❏ Do not install the consumable products or maintenance parts that reach end of service life into the

printer.

For details about the handling precautions, see “Handling consumable products and maintenance

parts” on page 15.

Replacement Messages

If a consumable product or maintenance part reaches the end of its service life, the printer displays the

following lights on the panel or the window of EPSON Status Monitor. When this happens, replace the

depleted consumable product or maintenance part.

Note that the toner cartridge supplied with your printer is partly used during the initial setup,

therefore the cartridge prints fewer pages compared to subsequent toner cartridges.

Epson AcuLaser M2300/M2310/M2400/M2410 Series User’s Guide

Replacing Consumable Products/Maintenance Parts 68