User`s guide

When you turn this setting on, the printer automatically continues printing after a certain period of
time when one of the following errors occurs: Paper Set, Print Overrun, or Memory Overflow.
When this option is off, you must press the Start/Stop button to resume printing.
Page Protect
Allocates additional printer memory for printing data, as opposed to receiving it. You may need to
turn this setting on if you are printing a very complex page. If a Print Overrun error message appears
on the LCD panel during printing, turn this setting on and reprint your data. This reduces the amount
of memory reserved for processing data so your computer may take longer to send the print job, but it
will allow you to print complex jobs. Page Protect usually works best when Auto is selected. You
will need to increase your printer’s memory if memory errors continue to occur.
Note:
Changing the Page Protect setting reconfigures the printer’s memory, which causes any downloaded
fonts to be deleted.
A4/LT Auto Switching
When A4 or Letter size paper is selected for printing and there is no paper of that size loaded, the
printout is output in another size.
Toner Alert
Specifies whether or not to stop printing temporarily when the imaging cartridge is near the end of the
service life.
LCD Contrast
Adjusts the contrast of the LCD panel. Use the u Up and d Down buttons to set the contrast between
0 (lowest contrast) and 15 (highest contrast.)
RAM Disk
Specifies the RAM disk size available for the Reserve Job function. See the table below for details.
Optional RAM capacity
(Total RAM capacity)
RAM Disk setting
Off Normal Maximum
128 MB (Total 192 MB) Disabled 64 MB 96 MB
256 MB (Total 320 MB) 128 MB 192 MB
Epson AcuLaser M7000 Series User's Guide
Using the Control Panel 67