Seiko Epson Corporation WLAN / BT Module / WLU5630B-D101(RoHS) OPERATION MANUAL
Install driver Connect WLU5630B-D101(RoHS) with cable to host device, and install drive.
In Linux system, execute Terminal with Superuser permission (sudo su) Permission, goto “init.sh” folder, and execute “./init.sh” to enable driver.
Access to WiFi & Bluetooth service: Follow Host device instruction to connect/access Wireless/Bluetooth service.
Regulatory statement FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20cm de distance entre la source de rayonnement et votre corps.
Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authorizations (e.g. SDoC) of the host product to be addressed by the integrator/manufacturer. This module is only FCC authorized for the specific rule parts 15.247, 15.407 listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host product as being Part 15 Subpart B compliant. NCC Statement 1.
Regulatory statement (for end-product) Label of the end product: FCC: The host product must be labeled in a visible area with the following " Contains FCC ID: BKMAE-WLU5630". Canada/ISED: The final end product must be labeled in a visible area with the following: “Contains IC: 1052D-WLU5630”.
Taiwan/NCC 1. 經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加 大功率或變更原設計之特性及功能。 2. 低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停 用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低 功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 3.