User`s guide

Home > Safety
Important Safety Instructions
Restrictions on Copying
Read all these instructions, and follow all warnings and instructions marked on the scanner.
In this document, warnings, cautions, and notes indicate the following:
Warnings
must be followed carefully to avoid bodily injury.
Cautions
must be observed to avoid damage to your equipment.
Notes
contain important information and useful tips on the operation of this product.
Place the scanner close enough to the computer for the USB cable to reach it easily. Do not place or store
the scanner or the AC adapter outdoors, near excessive dirt or dust, water, heat sources, or in locations
subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light sources, or rapid
changes in temperature or humidity. Do not use with wet hands.
Place the scanner and the AC adapter near an electrical outlet where the adapter can be easily unplugged.
Caution:
Be sure the AC power cord meets the relevant local safety standards.
The AC power cord should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place
objects on top of the AC power cord and do not allow the AC adapter or the power cord to be stepped on or
run over. Be particularly careful to keep the AC power cords straight at the end and the point where it enters
the AC adapter.
Use only the AC adapter that comes with your scanner. Using any other adapter could cause fire, electrical
shock, or injury.
The AC adapter is designed for use with the scanner with which it was included. Do not attempt to use it with
other electronic devices unless specified.
Use only the type of power source indicated on the AC adapter’s label, and always supply power directly from
a standard domestic electrical outlet with the AC adapter that meets the relevant local safety standards.
When connecting this product to a computer or other device with a cable, ensure the correct orientation of
the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong
orientation may damage both devices connected by the cable.
Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and
off.
If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged into